|
Our general carpet cleaning process includes:
-
Inspection and spot treatment.
-
Application of detergent to carpets.
-
Agitation of detergent to get better penetration into carpet fibers.
-
Allowing the product to dwell for 5-10 minutes to break soils loose from carpet fibers.
-
Rinse extraction with clean, 200 – 220 degree water with no detergents added. This removes both the soil and our detergent from the carpets, leaving little to no detergent residue behind.
-
Treat any spots that did not come out with the general cleaning.
-
Applying Teflon or Scotchgard protector to the cleaned carpet – additional charges apply.
All of our work is guaranteed. We follow up with you in 48 hours to make sure you are satisfied with the service. If not, we will come back and re-service at no additional charge.
 Upholstery cleaning process includes:
1. Pre-testing the piece for cleanability
2. Wet cleaning the piece by applying the detergent, agitating with a clean towel, allowing the detergent to dwell for 5-10 minutes, and rinsing the piece with clean hot water.
OR -
Cleaning the piece with detergent foam by hand.
OR- Cleaning the piece with dry cleaning fluids by hand.
The cleaning method used will depend on the type of fabric being cleaned. Call for more information.
Tile and Grout Cleaning:
-
We first vacuum the floor to be cleaned
-
A grout cleaner is applied – both regular and green products available
-
The cleaner is scrubbed into all the grout lines and over the tile
-
The cleaner is allowed to dwell for 10 minutes
-
The floor is rinsed with high pressure, high heat using a special tile tool
-
The edges are rinsed with high pressure and heat using an edging tool
-
The floor is dried using high velocity air movers
-
The grout lines are then sealed individually
-
Once dry, you can walk on the floor as normal
We also can perform your spring cleaning, post-construction cleaning, or move-in/move-out cleaning.
Contact us for more information or to schedule a cleaning. |
Carpet cleaning